![pclp cross exe pclp cross exe](https://i1.wp.com/www.betantt.com/wp-content/uploads/2021/06/ICON-BETANTT-1.png)
Be sure to allow the required space around the machine for servicing and proper ventilation. If a lighting fixture is connected to the same outlet, the light may flicker. Note : Connect the machine to a power outlet which is not used for other electric appliances. Also make certain the outlet is properly grounded. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. The machine should be installed near an accessible power outlet for easy connection and disconnection.
PCLP CROSS EXE INSTALL
Do not install your machine in areas that are: Leave the machine at room temperature for at least 2 hours before use. Operation in this condition will cause poor copy quality and malfunctions. Caution : If the machine is moved from a cool place to a warm place, condensation may form inside the machine. Please note the following during initial installation and whenever the machine is moved.
![pclp cross exe pclp cross exe](https://i.ytimg.com/vi/EGU2EwbcIS0/maxresdefault.jpg)
Note for installation place Improper installation may damage the machine.
![pclp cross exe pclp cross exe](https://tylasopa989.weebly.com/uploads/1/2/5/7/125797137/315195475.jpg)
When the machine is not used for a long time, for example, during prolonged holidays, turn the power switch off and remove the power cord from the outlet.Do not install the machine in a humid or dusty location.Place the machine on a firm, level surface.Machine power must be turned off before installing any supplies.After turning the machine off, wait 10 to 15 seconds before turning it back on. Do not switch the machine rapidly on and off.It may damage eyes by reflection of laser beams.ī. Do not insert a reflective material such as a screwdriver in the laser beam path. Exercise care in this area when removing misfed paper. Note for servicing Pictogram The label ( ) in the fusing area of the machine indicates the following: : Caution, risk of danger : Caution, hot surface Tray paper feed section/Paper transport section. EXTERNAL VIEWS AND INTERNAL STRUCTURES 1. High voltage section/Duplex transport section.10 - 1 2. Note for replacement of consumable parts. Remove the battery from the product and contact federal or state environmental agencies for information on recycling and disposal options. LASER WAVE - LENGTH : 795 Pulse times : 0.481ms/6mm Out put power : 5mWĬAUTION FOR BATTERY DISPOSAL (For USA,CANADA) Contains lithium-ion battery. The contents are subject to change without notice.ĭisconnect the AC cord before servicing the unit. This document has been published to be used for after sales service only.
PCLP CROSS EXE MANUALS
SHARP CORPORATION Downloaded from manuals search engine Be sure to replace these parts with specified ones for maintaining the safety and performance of the set. Parts marked with “ “ are important for maintaining the safety of the set. 4 - 1 EXTERNAL VIEWS AND INTERNAL STRUCTURES.